PROPERTIES
Super-strong (up to 170 kg/cm²)
Resistant to temperatures between -40 °C and +100 °C
Filling
Water resistant
Chemical resistant
Paintable
SUITABLE FOR:
Suitable for repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex®).
NOT SUITABLE FOR:
Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.
HANDLING
BEFORE USE:
Working conditions
Only apply at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and the hardener.
Personal safety
Preferably wear gloves.
Surface requirements
The surface must be dry, clean and free of dust and grease.
Preliminary surface treatment
Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper).
Coverage
1 ml = approx 10 cm² at a film thickness of 1 mm
Advice
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.
Points of attention
Close well after use. For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.
AFTER USE:
Stains/residue
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.
Storage conditions
Store in tightly closed packaging in a dry, cool and frost-free place.
